[papercreters] More beerpercrete

Yesterday I made four more panels with embedded bottles. By the last one my method had evolved from carefully placing the bottles in a pattern, to just dumping a bucket of a couple dozen bottles into the mostly filled mold, pressing them down, and then topping off to completely fill the mold.

As I was finishing up a cold front blew in, and the temperature dropped 25 degrees in a couple of hours. This morning it is 20F outside. Just before dawn it rained a bit, and now everything is covered with a film of ice.

So far the only protruding bottle is one that had its bottom against the mold. It's not actually protruding, just at the surface with no pc cover. That surface will mate to another triangle, so the bottle will ultimately be covered.

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___