Check the ones I made out under Kens stuff in the phote section.
4 x 4 x 1/2 inch angle for the base, 3 inch drill pipe for the rollers.
1 1/2 inch cold rolled steel axles full length of the rollers to the
blocks, 3inch x 1/4 washers to tie the axle to the pipes. 1 1/2 inch
pillow blocks as the contacts/supports,I have used them almost daily
for years. Little grease in the blocks every month and they go and go.
--- In papercreters@yahoogroups.com, "daleandbren" <daleandbren@...>
wrote:
>
> I tried conveyor rollers, bearings only lasted one batch. I need
> rollers with high speed bearings, or pillow block bearings that can
> handle the weight and speed. Anybody have some experience with using
> rollers. -Dale
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/papercreters/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/papercreters/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:papercreters-digest@yahoogroups.com
mailto:papercreters-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
papercreters-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
