[papercreters] PTO Mixer Photos sealing the vertical shaft

Hi Nori,

There is a piece of 1/8" tightly machined teflon that was put on the shaft, and then when the gear box was mounted to the horizontal mounting plate it was captured.  I'm also putting a piece of 1/16" rubber gasket between the bottom of the tank and the gear box mounting plate, captured by a piece of metal located inside the tank and bolted through the tank to the gear box mounting plate.  Hopefully the two combined will keep water out.  Also, I will store the tank so water doesn't collect arount the shaft.

Eric

At 07:48 PM 3/21/2008, you wrote:

Eric, what kind of seal do you have on the shaft between your gear box and the blade?
 
My gearbox looks very different than yours with a side mount, not a surface mount.  I've got a lot of cleaning up to do before I can think of mounting it.
 
I've uploaded the photo.  The access panel is on the (will be) bottom of the gear box.  The gearbox will need a vertical mounting surface.
 
ElfN

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___