[papercreters] Re: Paint that has frozen

see messages 10020 and 10119

I just last week covered over an old double wood door and a glass
exterior door, meaning I left the doors in place in a concrete block
wall and slip formed PC on both sides of the doors, I don't have any
pictures of the doors before I slip formed over them but I will send
pictures of the finished wall inside and outside in my next message.


--- In papercreters@yahoogroups.com, "liberty1_27606" <liberty1@...>
wrote:
>
>
>
>
> Cris,
>
> Did I get it right? 1. You put acrylic paint in your basic papercrete
mix. 2. You make the next to last coat a plaster with several
components, including acrylic paint. 3. Your top coat is acrylic paint.
>
> Your oldest building was finished several years ago and when you dig
into it, the papercrete is not damp? If you scratch through the paint
and plaster, the papercrete is still doing OK?
>
> If this works, I will have to revise my theory (my comments are based
solely on paranoia about waterproof coatings over materials that should
not be wet, not experience). If it works, it works, let's use it.
>
> Bobby
>
> --- In papercreters@yahoogroups.com, "countryatheartok" criswells.ok@
wrote:
> >
> >
> >
> > Clyde is right! I always use latex or acrylic in all my mixtures, if
I am making a finish coat I use drywall mud, latex or acrylic paint,
portland cement and fine sand blasting sand. Then after this has dried,
I paint with exterior latex or acrylic paint. I have never had a problem
with water getting in and not getting out. I would never use paint
thinners like linsed oil, acetone, spirit etc., or oil based paints.
> >
> >
> > --- In papercreters@yahoogroups.com, "Clyde T. Curry" <clydetcurry@>
wrote:
> > >
> > > Sorry to disapoint ya but acrylic paint has a large molecule and
breaths rather well - do not under in circumstance use oil base or
thinners - you will never get rid of the smell - make sure water can
roll off, down hill at any rate - do not allow water to puddle- hugger
of trees knows all this - trust her - Clyde T. Curry
> > >
> > >
> > > ________________________________
> > > From: Ashok Mathur <ashokchand2000@>
> > > To: "papercreters@yahoogroups.com" papercreters@yahoogroups.com
> > > Sent: Saturday, June 2, 2012 3:05 AM
> > > Subject: [papercreters] Re: Paint that has frozen
> > >
> > >
> > > Â
> > > Most paint that has frozen/ become lumpy can be quickly set right
by adding some quantities of paint thinners like linsed oil, acetone,
spirit etc.
> > > You need to find out the composition of the paint, then it will be
easy to find out its thinner.
> > > Â
> > > Regards
> > > Ashok
> > >
> >
>





------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/papercreters/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:
http://groups.yahoo.com/group/papercreters/join
(Yahoo! ID required)

<*> To change settings via email:
papercreters-digest@yahoogroups.com
papercreters-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
papercreters-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/