Wednesday, May 21, 2008

Re: [papercreters] Thought

Weight it again in another 14-21 days. I will bet the weight will be really close to the original weight. This material does not behave like concrete as the cement is only a binder when used in the normal/conventional 1-1 by weight formula. When you start increasing the cement ratio up to 1-2 or 1-4 paper-cement, the material starts acting more like cement. And if you add sand to the mixture you are getting closer to a conventional lightweight cement.
This is the first time I believe anyone has done this type of measurement. Out of curiosity, is there a reason for you doing this?

Lawrence Arnold <larystoy@yahoo.com> wrote:
Perhaps a stupid question, but an interesting one:
 
If you use X amount in inert materials (Paper, Concrete and sand) and Y amount of water. Would the dried papercreate equal the value of the inert materials?
 
During my introduction to papercreate, I built a 1' X 2' X 5" block, and after about two weeks of drying time the block weighs 21 lb. The total weight of the inert materials is 16 1/2 lbs. and 7 gallons of water. This than leaves 4 1/2 lbs of what?
 
7.0   gallons of water
4.5   pounds of paper
7.5   pounds of Portland cement
4.5   pounds of pumas
Will the block eventually dry to the 16 1/2 pounds of inert materials?
 
Larry in NE Arizona
 



__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___