Alexis,
Generally most of us don't let the slurry mix drain at all but rather put it in forms or on a wall right away. It would depend on what you are doing with it. If you are spraying it on a wall you would want most of the moisture in it to allow it to be blown. If you are using it to make bricks you could allow the water to drain off while you do something else. Where would you store it? How would you get it there? All these would add time and handling so most of us just pour it into the forms or to its final place just so we can relieve the mixer for the next batch.
There is a movement afoot to compress the blocks, but the only brick press currently available I am aware of is $25,000. This is excessive and some in this group feel a cheaper method can be designed and built. Some of us are playing with presses and ways of doing it cheaper.
I guess the answer to your question is until the cement starts getting hard, for sure a couple of days before that happens even in a nice hot dry climate and even longer in cooler more humid areas.
If you have a mold, build a tamper that you can stand on, and push the water out the bottom of your mold. You may want to drill holes all around the sides and ends of the form to allow more drainage. Maybe put a layer of hardware cloth on the bottom (1/4" mesh) to allow the drainage to happen faster.
Good luck!
Ron
Generally most of us don't let the slurry mix drain at all but rather put it in forms or on a wall right away. It would depend on what you are doing with it. If you are spraying it on a wall you would want most of the moisture in it to allow it to be blown. If you are using it to make bricks you could allow the water to drain off while you do something else. Where would you store it? How would you get it there? All these would add time and handling so most of us just pour it into the forms or to its final place just so we can relieve the mixer for the next batch.
There is a movement afoot to compress the blocks, but the only brick press currently available I am aware of is $25,000. This is excessive and some in this group feel a cheaper method can be designed and built. Some of us are playing with presses and ways of doing it cheaper.
I guess the answer to your question is until the cement starts getting hard, for sure a couple of days before that happens even in a nice hot dry climate and even longer in cooler more humid areas.
If you have a mold, build a tamper that you can stand on, and push the water out the bottom of your mold. You may want to drill holes all around the sides and ends of the form to allow more drainage. Maybe put a layer of hardware cloth on the bottom (1/4" mesh) to allow the drainage to happen faster.
Good luck!
Ron
(Alexis said)
Hi,
I am wondering how long you can let papercrete drain before placing it in it's final form or mold without it starting to set.
Alexis
__._,_.___
