Compressing slurry can take many forms. Following are a few ideas.
NONE OF WHICH I'VE TRIED AT A PRODUCTION SCALE. I've played with all
these concepts successfully on a SMALL SCALE. Experiment all you
want at your own risk. Be careful out there gang.
Compressing slurry to make blocks might be easiest. I envision a
contraption similar to the Cinva system for making compressed earth
or adobe blocks. Imagine if a cinva were built using a perforated
box? Water could easily drain out as the block is getting
compressed. Think of a big industrial strength potato ricer! (btw,
a regular potato ricer works really well for small scale
experiments. Make sure you clean it before returning it to the
kitchen or incur the wrath of the family cook!!! slurryguy claims no
responsibility for injuries resulting from flying cookware thrown by
angry cooks.) Several hundred psi seems reasonable in a block
press. It would also be easy to reclaim the water draining out of a
press and recycle it back into the next batch of slurry.
Compressing slurry in a block making slipform like Judith uses might
be as simple as laying some lumber across the top of the form just
covering the slurry, but not overlapping the form. The vehicle
towing the mixer might be driven over the top after some initial
draining, thereby compressing the mix into the form. I wonder if the
slurry might try to ooze out from under the sides of such a form, so
I'm not certain if this would work well. If someone tries it, please
be careful to not damage your vehicle. This concept may need to have
some bugs worked out to make it work.
Compressing slurry while slipforming would be more difficult, but
still could be done. Imagine someone were using a wall system
similar to the diagram posted in the photos section for a bailing
twine reinforced wall. With each lift of slurry poured into the
slipform, a box beam could be laid across the top of the slurry so
that it nests inside the slipform. Long strap clamps could be looped
over the wall and attached to the rebar staples embedded in the
foundation as shown in the diagram. The box beam would obviously be
removed before the next lift of slurry were poured.
Cast in place walls could be compressed in a similar manner to that
described for slipforming.
I cannot think of a good method to compress sprayed slurry. The
variables about the shape and location of the potential surfaces are
too many to wrap my feeble brain around.
--- In papercreters@yahoogroups.com, <bob@...> wrote:
>
> Good thinking- I like the thought process. If your form has a
trough on top
> with a water repellent barrier- then you could use water to
compress the
> slurry-more water more compression. What is water about 8 pounds to
the
> gallon? Bob C
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/papercreters/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/papercreters/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:papercreters-digest@yahoogroups.com
mailto:papercreters-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
papercreters-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
